User manual
Table Of Contents
- Contents
- Package Contents
- Camera Unit Pack
- Accessory Pack
- Introduction
- Features and advantages
- System Introduction
- Hardware Installation
- Camera Setting from a Router
- Enter the Main Page
- Camera Main Page
- Basic Settings
- Basic Setting > System (System info)
- Basic Setting >Video/Image
- Basic Setting > Audio (Sound)
- Basic Setting > User(User)
- Basic Setting > Network (Network Settings)
- Basic Setting > Network > Network (cable network setting page)
- Basic Setting > Network > Streaming (streaming Setting)
- Basic Setting > Network > PPPoE (dial-up networking setting)
- Basic Setting > Network > DDNS (Dynamic Domain Name Server Setting)
- Basic Setting > Network > UPnP (Universal Plug and Play)
- Basic Setting > Network > SMTP Server (mail server setting)
- Basic Setting > Network > Samba
- Basic Setting >\ Network >\ Multicast
- Basic Setting > Date/Time (date/time setting)
- Basic Setting > IP Filter
- Application Setting > Event (event trigger setting page)
- Application Setting > Firmware upgrade
- Application Setting > Factory Default
- Application Setting > Reboot
- Attachment A: External Alarm
- Attachment C: Troubleshooting and FAQs
- FCC Class B Announcement
DDNS setting
Basic Setting > Network > UPnP (Universal Plug and Play)
If you connect your camera to a router, IP allocator, or wireless AP, your camera will
possibly be blocked by the NAT and can’t be located on the Internet. To penetrate the
firewall, activate the supportive item- UPnP. The Link URL shows the external IP
address and the port of the router. Enter the IP address in the Internet Explorer to
penetrate the NAT.
Basic Setting > Network > UPnP > UPnP Device
Active: yes (enable)/no (disable)
Device Name: the name of the UPnP device
Basic Setting > Network > UPnP > UPnP Traversal
Active: yes (enable)/no (disable)
Port Range: the range of the usable ports, from 32768 to 65535 as default
Link URL location: After the network camera penetrates the firewall successfully,
the actual external IP address and port will be shown.
Click “Save” to confirm when you finish.
60