User manual
Table Of Contents
- Contents
- Package Contents
- Camera Unit Pack
- Accessory Pack
- Introduction
- Features and advantages
- System Introduction
- Hardware Installation
- Camera Setting from a Router
- Enter the Main Page
- Camera Main Page
- Basic Settings
- Basic Setting > System (System info)
- Basic Setting >Video/Image
- Basic Setting > Audio (Sound)
- Basic Setting > User(User)
- Basic Setting > Network (Network Settings)
- Basic Setting > Network > Network (cable network setting page)
- Basic Setting > Network > Streaming (streaming Setting)
- Basic Setting > Network > PPPoE (dial-up networking setting)
- Basic Setting > Network > DDNS (Dynamic Domain Name Server Setting)
- Basic Setting > Network > UPnP (Universal Plug and Play)
- Basic Setting > Network > SMTP Server (mail server setting)
- Basic Setting > Network > Samba
- Basic Setting >\ Network >\ Multicast
- Basic Setting > Date/Time (date/time setting)
- Basic Setting > IP Filter
- Application Setting > Event (event trigger setting page)
- Application Setting > Firmware upgrade
- Application Setting > Factory Default
- Application Setting > Reboot
- Attachment A: External Alarm
- Attachment C: Troubleshooting and FAQs
- FCC Class B Announcement
20. Remove the outer packaging of the
optical cover and align the optical cover
with the gap of the PTZ Dome Camera.
Put the cover to its position, turn right to
the end, and remove the protection film.
Do not leave any fingerprints on the
cover
Note: While installing, be careful not to scratch or leave fingerprints on the optical cover.
Gloves are recommended for the installation. Dust may accumulate to the optical cover
after prolonged use and affect the image quality. A high-pressure gas spray can be used
to remove the dust. If the dust accumulation is severe, remove the optical cover, clean
with water, dry and wipe it carefully with a wiper (optical lens wiper). It is not allowed
to use any harsh solvents to clean the optical cover. A new replacement is available if the
optical cover is damaged to affect the image quality
.
Important!!
1. Users should carefully read the attached Hardware Installation Manual to avoid
damage to the equipment and personnel.
2. If you want to hang the camera from the ceiling, please do not affix this product to
the asbestos plate on the lightweight steel frame. The fragile asbestos plate might not
be capable of holding the weight and the camera may fall from the ceiling to injure
personnel or damage the equipment. It is recommended to secure the camera on a
rigid surface, such as wooden plate, concrete, metal surfaces. The attached screws
are used for wooden plate. Please use other appropriate screws if the camera is to be
secured to a surface made from different material.
3. When using a screw to fix the camera to the ceiling, please protect your eyes from
falling screws.
4. Reminder, you can fix the camera to the ceiling after setting the camera.
5. Do not forget to clean and maintain the camera -
Dust may adhere to the optical cover after prolonged use and affect the image
quality. Remove the optical cover, clean with water, dry and wipe it carefully with a
wiper (optical lens wiper).
After completion of the hardware installation:
1. Connect the network cable
Connect one end of the network cable (not supplied) to the network port on the
rear panel. Connect the other end to the network equipment of the user.
2. Connect to power supply
Connect the power supply (not supplied) to the power inlet. The camera will
automatically rotate. It takes about 40 seconds to activate the camera.
22