User manual
Table Of Contents
- Contents
- Package Contents
- Camera Unit Pack
- Accessory Pack
- Introduction
- Features and advantages
- System Introduction
- Hardware Installation
- Camera Setting from a Router
- Enter the Main Page
- Camera Main Page
- Basic Settings
- Basic Setting > System (System info)
- Basic Setting >Video/Image
- Basic Setting > Audio (Sound)
- Basic Setting > User(User)
- Basic Setting > Network (Network Settings)
- Basic Setting > Network > Network (cable network setting page)
- Basic Setting > Network > Streaming (streaming Setting)
- Basic Setting > Network > PPPoE (dial-up networking setting)
- Basic Setting > Network > DDNS (Dynamic Domain Name Server Setting)
- Basic Setting > Network > UPnP (Universal Plug and Play)
- Basic Setting > Network > SMTP Server (mail server setting)
- Basic Setting > Network > Samba
- Basic Setting >\ Network >\ Multicast
- Basic Setting > Date/Time (date/time setting)
- Basic Setting > IP Filter
- Application Setting > Event (event trigger setting page)
- Application Setting > Firmware upgrade
- Application Setting > Factory Default
- Application Setting > Reboot
- Attachment A: External Alarm
- Attachment C: Troubleshooting and FAQs
- FCC Class B Announcement
5. The adjusting screw determines the height of
the PTZ Dome Camera beneath the ceiling.
Turn the screw clockwise to extend the
camera, or turn the screw counterclockwise to
draw back the camera.
Note: When the inserting installation method is adopted, the three legs carry the total
weight of the camera. Thus, they should be firmly secured to avoid damage to the
equipment and personnel. If the surface to which the legs are secured is not level, adjust
the adjusting screw of each leg to level the camera.
6. Take the network module base out from the
camera unit pack.
7. Pull the steel wire out from the base.
8. Connect the steel wire to the hook on the PTZ
Dome Camera to prevent the accidental
falling of the camera.
18