Instruction Manual

7
It is possible to set different functions for [P1], [P2], [P3],[P4],[P5],[P6].
A,B,C,D.
Method 1: In radio Menu - Settings - Radio Set - P1~P6, PA-PD.
Method 2: In PC software - Public - Optional Setting - Key function.
Programmed Key
OFF No Function
Volt Check the current battery capacity voltage
Tx Power
Switch the power between high, middle, low and small power.
TalkAround Switch between Talk Around and Repeater mode
Reverse Turn on/off the frequency reverse function.
Digi Encrypt Choose the digital encryption group for digital channel
Call
In Analog mode, send the DTMF/5TONE/2TONE encode. This
function is only valid for analog channel. Before use call function,
set optional signal in advance.
VFO / MR Switch between VFO mode and memory channel mode.
Scan Scan on/off
AM/FM AM/FM On/Off, Off =>FM =>AM mode A =>AM mode B =>Off
Alarm
Long press the key to start alarm, short press again to exit the
alarm.
Record Switch Enable/disable the recording function
Record
Start/stop recording. When stop recording, the radio will remind
repeat or send the record. This functin is only valid for digital
channel.
SMS In digital mode, press to enter into SMS messages
Dial Start the manually dial
GPS Info Check the GPS position information
Monitor Monitor the weak signal or the signal with unmatched ID.
Main CH
Switch
Choose channel A or channel B as the main channel
Hot Key 1~6
Selects Hot Keys 1-6 Note: Hot key setup details on next page
Work Alone Turn on/off the work alone function.
Nuisance
Delete
During scanning, press the key to skip the unwanted channel
Digi Monitor In DMR mode, press the key to turn on/off digital monitor
Sub CH On/
Off
Turn on/ off the sub channel
Priority Zone Switch to Priority Zone
Program Scan
"Press the key to start the scan in VFO channel scan start and
end frequency must be programmed in PC software - Optional
Setting - VFO scan."
Enhanced
Sound
In digital channel, switch the microphone tone to normal or
enhanced mode.
LastCall Reply
In digital channel, press the key to access the last call and press
PTT to call back.
Switch
ChType
Switch the channel type(Analog, Digital, Ana+Dgi, Dgi+Ana)
Ranging
When the radio receives a call and the suspension time is on,
press the key programmed as" Ranging" to obtain the caller's
position and distance. (Both party need GPS positioned, or will
receive only GPS information)
Roaming
In standby, press the key programmed as "Roaming" to search
and lock on the repeater with strongest signal. (Note: After lock on
a repeater, the radio will return to last frequency only after channel
or frequency is changed. The repeater frequency list must pre-
programmed in CPS.)
3
Getting Acquainted