Instruction Manual

Occupational/Controlled Use
This product is used in situations that users are exposed to RF as
consequence of their employment provided those users are fully aware
of the potential RF hazards and can exercise control over their exposure.
•
This transceiver is NOT ATEX approved and NOT intended for the use
in hazardous explosive atmospheres.
Electromagnetic Interference/Compatibility
Electronic devices are susceptible to electromagnetic interference (EMI)
if they are not adequately shielded or designed for electromagnetic
compatibility. Because this transceiver generates RF energy, it can cause
interference to such equipment.
•
Turn OFF your transceiver where signs are posted to do so.
Hospitals and health care facilities use equipment that is sensitive to
electromagnetic radiation.
IMPORTANT:
Not all features are available to users due to programming. The units
are programmed by the dealer before sales therefore some features
may be prohibited for manual access by the users. For this reason, it
is suggested that users learn how to operate the units directly from the
dealer who programmed the functions and channels. Please contact the
dealer for any technical inquiry because the distributor and manufacturer
are notaware of the details of dealer-programming.
• Do not transmit for more than 50% of the total transceiver use time;
transmitting over 50% of the total use time may exceed the limits in
accordance to the FCC RF exposure requirements. Nominal transceiver
operation is 5% transmission time, 5% reception time, and 90% stand-by
time.
NOTE:Antenna gain including cable loss must not exceed 0.28 dBi for
satisfying RF exposure limit
RF energy, or in which the persons who are exposed as a consequence
of their employment may not be fully aware of the potential for exposure
or cannot exercise control over their exposure.
This device complies with part 15 of the FCC Rules. Operation is subject
to the following two conditions: (1) This device may not cause harmful
interference,and (2) this device must accept any interference received,
including interference that may cause undesired operation.
FCC Radiation Exposure Statement:
This equipment complies with FCC radiation exposure limits set forth for an
uncontrolled environment .This equipment should be installed and
operated with minimum distance 50cm between the radiator& your body.