Instruction Manual
4
2
Initial Installation
Before connecting the DC power to the transceiver, be sure to switch
the transceiver and the DC power supply OFF.
Do not plug the DC power supply into an AC outlet until you make all
connections.
2.
Connect the transceiver's DC power connector to the connector on
the DC power cable.
Press the connectors rmly together until the locking tab clicks.
REPLACING FUSES
If the fuse blows, determine the cause, then correct the problem. After
Only use fuses of the specied type and rating, otherwise the transceiver
could be damaged.
Fuse Location Fuse Current Rating
Transceiver 15A
Supplied Accessory DC
power cable
15A
If you use the transceiver for a long period when the vehicle battery is
not fully charged, or when the engine is OFF, the battery may become
discharged, and will not have sufcient reserves to start the vehicle. Avoid
using the transceiver in these conditions.
Red
Black
DC power cable with fuse holder
Regulated
power supply
The current capacity of your power supply must be 12A or more.
1.
Connect the DC power cable to the regulated DC power supply and
ensure that the polarities are correct. (Red: positive, Black: negative).
Never directly connect the transceiver to an AC outlet.
Use the supplied DC power cable to connect the transceiver to a
regulated power supply.
Do not substitute a cable with smaller gauge wires.
the problem is resolved, replace the fuse. If newly installed fuses
continue to blow, disconnect the power cable and contact your dealer for
assistance.
Before operating, install an efficient, well-tuned antenna. The success
of your installation will depend on the type of antenna and its correct
installation.
Use a 50Ω impedance antenna and low-loss coaxial feed-line that
has a characteristic impedance of 50Ω, to match the transceiver input
impedance. Coupling the antenna to the transceiver via feed-lines having
an impedance other than 50Ω reduces the efficiency of the antenna
system and can cause interference to nearby electronic equipment.
Antenna Connection