Instruction Manual

2
1.
Install the mounting bracket in the vehicle using the supplied self-
tapping screws (4pcs) and at washers (4pcs).
2
Car body
Washer (M5)
Tapping screw
(M5x20mm)
Mounting bracket
Initial Installation
Mobile installation

Determine the appropriate angle of the transceiver, using the 3
screw hole positions on the side of the mounting bracket.
The transceiver may be installed in any position in your car, where the
controls and microphone are easily accessible and it does not interfere with
the safe operation of the vehicle. If your vehicle is equipped with air bags,
be certain your transceiver will not interfere with their deployment. If you
are uncertain about where to mount the unit, contact your vehicle's dealer.
Caution:
Use only the provided screws
otherwise you risk damaging
the circuit board, components
or fall-off of the unit.
2.
Position the transceiver, then insert and tighten the supplied hexagon
SEMS screws.

Double check that all screws are tightened to prevent vehicle
vibration from loosening the bracket or transceiver.
Prepare screwdriver to fasten and loosen screws.
3.
To remove the transceiver, unscrew all xing hardware,and hold the
transceiver in the way that it won't fall from bracket.