Instruction Manual

24
8
Reverse TX/RX
Refer to P.18 for details.
1.
In standby, press , then press , LCD displays “
REV—OF
”.
2.
Press [ / ] to select the desired value.
ON:Enable Frequency Reverse
OFF:Disable Frequency Reverse
3.
Press number keys to conrm and exit.
In corresponding mode, press then press key to start scanning.
In scanning mode, press / to change scan direction.
Press [PTT] to stop scanning.
Busy Channel Lockout
Refer to P.18 for details.
1.
In standby, press , then press to enter into Busy Channel
Lockout.
2.
Press [ / ] to select the desired value.
BU: Enable BCLO, Carrier lockout, transmitting is inhibited when
current channel receives a matching carrier; press [PTT] to emit
error voice prompt.
RL: Enable BTLO, transmitting is inhibited when current channel
receives a matching carrier but dis-matching CTCSS/DCS. Press
[PTT] to emit error voice prompt It can transmit in any receiving
status.
OFF: Busy channel lockout is disabled.
3.
Press number keys to conrm and exit.
This function can be temporarily used in memory mode. Once the
radio is turned off or switched to another channel, the temporary
setting will be erased and back to initial settings.
Frequency/Channel scan
Scan Skip
(
To exclude selected channels from memory scanning
)
In memory mode, press then press , decimal point appears.
It means current channel is scan skip. Repeat above operation to set
scan or scan skip in current channel. Decimal point dissapears when the
channel is available for scanning.
TOT (Time-out timer)
Refer to P.19 for details.
1.
In standby, press , then press LCD displays "
TOT-X
".
2.
Press [ / ] to select the desired value.
3.
Press number key to conrm and exit.
CTCSS/DCS Encode and Decode
1.
In standby, press , then press to enter into CTCSS/DCS
Encode and Decode.
2.
Repeat above operation to set as below:

LCD displays icon, it indicates CTCSS encode set in current
channel.

LCD displays and icon, it indicates CTCSS encode and
decode set in current channel.

LCD displays
DCS
icon, it indicates DCS encode and decode set
in current channel.
Microphone Operation