Instruction Manual
13
5
KEY OPERATIONS
The standard set of 50 different CTCSS tones are available. DCS
encode/decode cannot be separated. The list of selectable tones and
codes is shown on Appendix at the end of this manual.
CTCSS SCAN
While receiving CTCSS signal, press
P3
key
to select or
TSQ
then hold
P3
key until
starts scanning. Once finding a matching
CTCSS tone, a voice will be heard and
resumes scanning after 15 seconds.
Press any key except
PWR
and
FUNC
key to exit.
While receiving DCS signal, press
P3
key to select DCS then hold
P3
key until starts scanning. Once finding a
matching DCS code, a voice will be heard and
resumes scanning after 15 seconds.
Press any key except
PWR
and
FUNC
key to exit.
Press
FUNC
key to display icon, then press
P4
key to switch between high/Mid/low
power.
None
: Transmits in high power 50W
: Transmits in middle power 20W
: Transmits in low power 10W
HIGH/MID/LOW Power SETTING
DCS SCAN
1.
Press and hold
P2
key for over 2
seconds, LCD displays offset direction
and offset frequency.
2.
Repeatedly press
P2
key to select
positive offset or negative offset.
3.
When LCD displays " " icon, it indicates positive offset, which
means transmitting frequency higher than receiving frequency.
Repeater receives a signal(UP-LINK) on one frequency and re-transmits
on another frequency(DOWN-LINK). The difference between these two
frequencies is called the offset frequency. If the UP-LINK frequency is
higher than DOWN-LINK frequency, the direction is positive, If it is lower,
the shift direction is negative.
Offset Direction and offset frequency setup
4.
When LCD displays " " icon, it indicates negative offset, which
means transmitting frequency lower than receiving frequency.
5.
Mic's [ / ] key to change offset frequency in
accordance with the step setting.
6.
Press any key except
FUNC
and
P2
key to set and nish setting.
In memory mode, this operation can be temporarily available.
This operation is possible also in the memory mode but
temporaly. Changing frequencies or turning off the radio will reset
the setting.