Instruction Manual

11
Basic Operations
Transmitting Tone BURST TONE
Transmitting OPTIONAL SIGNALING
Press and hold [PTT] key, then press Microphone key to transmit
selected tone-burst tone. Pre-programming is necessary.
Press and hold [PTT] key, then press Microphone key to
transmit pre-stored and selected DTMF/2Tone/5Tone optional signaling.
Preprogramming is necessary.
●
Band Width
●
TX Power
●
CTCSS/DCS Encode / Decode
●
Optional Signal
●
TX Off
●
Scan Skip
●
Reverse / Talk Around
●
Busy Channel Lock-Out
In memory mode, the setting may be changed temporary but changing
a channel or turning off the radio will cancel the operation and returns to
programmed setting.
MEMORY CHANNEL PROGRAMMING
Memory Channel Function List
MEMORY CHANNEL DELETING
1.
Be sure the undesired functions are turned off before programming.
Memory channels hold setting like signaling and power settings.
2.
If you wish to include settings such as signaling and power in the
memory, Set them to the VFO in advance to the memory programming
operation. Refer to the list on the right for parameters you may include in
a memory channel.
3.
Press
FUNC
key, LCD appears , and
current channel appear on LCD. Flashing
means the current channel is empty.
4.
Press or Key to select the
desired channel number to store.
5.
Press key, , icon and channel
number disappears and beep sounds twice.
6.
Press key again to confirm that the memory channel is properly
stored.
1.
Under Memory mode, input by MIC's numeric keys to select
channel to be deleted. For example, choosing CH1, press [0] [0] [1].
2.
Press
FUNC
key, LCD appears icon, then press
P2
key, current
memory will be deleted and a beep sounds twice. icon ashing
means current memory channel is deleted. Can not delete all
memory channels, at least one channel will be saved.
4
While transmitting, LED lights RED and TX-meter shows relative power level.
Release PTT to receive.

Speaking too loud distorts, too undertone won't modulate enough your
voice.