Instruction Manual

4
2
Initial Installation
Be sure to turn off both the transceiver and power supply before start
setting and connections.
In order to use this transceiver for xed station operation, you will need
a separate 13.8V DC power supply (not included) , Please contact local
dealer to require.
The current capacity of your power supply must be 12A or more.
1.
Connect the DC power cable to the regulated DC power supply
and ensure that the polarities are correct. (Red: positive, Black:
negative).

Never directly connect the transceiver to an AC outlet.

Use the supplied DC power cable to connect the transceiver to a
regulated power supply.

Do not substitute a cable with smaller gauge wires.
2.
Connect the transceiver's DC power connector to the connector on
the DC power cable.

Press the connectors rmly together until the locking tab clicks.
Red
Black
DC power cable with fuse holder
Regulated
power supply
Fixed Station Operation
REPLACING FUSES
If the fuse blows, determine the cause, then correct the problem. After the
problem is resolved, replace the fuse. If newly installed fuses continue to
blow, disconnect the power cable and contact your dealer for assistance
.
Only use fuses of the specied type and rating, otherwise the transceiver
could be damaged.
Fuse Location Fuse Current Rating
Transceiver 15A
Supplied DC
power cable
15A
If you use the transceiver for a long period when the vehicle battery is
not fully charged, or when the engine is OFF, the battery may become
discharged, and will not have sufcient reserves to start the vehicle. Avoid
using the transceiver in these conditions.