Instruction manual

4.Basic Operation

1. Select the Memory mode by pressing the key, then rotate the dial to select .

2. The (minus) and icons appear on the display. By default, the values are:

DJ-S17E/TFH: minus shift, 0.6MHz offset, 88.5Hz CTCSS tone

DJ-S47E: minus shift, 7.6MHz offset, 88.5Hz tone

If these are the values you desire, no further setting is required so simply press the key

to go back to the operation mode. Refer to "Repeater-Access" on page 41 for operation.

3. To change the values instead, repeat the same setting sequence explained on page

26 for shift direction and offset frequency then page 37 for CTCSS tone by entering

to the Set mode while is displayed. Even if you desire the same

values you set for the respective parameters in the VFO mode, please repeat the

sequence in here to activate the Repeater-Access function.

4. After having completed the programming in the Set mode, return to the

menu by pressing any key except FUNC or MONI. Press the FUNC

key and while is displayed, press the key. A beep sounds and the new values

are stored in the memory.

4.5.6 Programmable Parameters in Memory Channels

The following parameters can be stored in each of the memory channels.

• Frequency • Offset frequency *

• Skip channel setting • Shift direction (+/-) *

• Busy channel lockout (BCLO) • Tone encoder frequency *

• Transmission power (H/L) • Tone decoder frequency *

• Battery save setting • Tone encoder/decoder setting (TSQ) *

• Clock Shift setting • DCS code *

• Alphanumeric channel tag • DCS setting *

• Attenuator Level

NOTE:

Only parameters marked "*" are programmable in Repeater-Access function memory.

NOTE:

･ You can not communicate in the channel.

･ The channel is skipped during scanning. You can not delete or

convert this memory to other purposes.