Instruction manual
60
3.1.30 Directly changing the settings
This function allows you to enable/disable the direct changes of the settings for
modulation mode, frequency step, attenuator, and CTCSS decoding function in
the MR or PMS modes. When it is turned ON, the settings for modulation mode,
frequency step, attenuator, and CTCSS decoding function can be directly
changed in the currently displayed MR or PMS mode.
1
Call up the DIRECT WR screen.
Press the key, and then press
the key while is shown
on the display.
The MENU will appear. Point the
arrow at +CONFIG using the dial or UP/DOWN key, and
then press the key.
The CONFIG screen will appear. Point the arrow at
+DIRECT WR and then press the key.
The DIRECT WR screen will appear.
2
Selecting ON/OFF for DIRECT WR.
Point the arrow at ON or OFF using the dial or UP/DOWN key, and then press
the key (the initial setting is OFF).
The display will return to the CONFIG screen. Point the arrow at END and then
press the key (Alternatively, you may press the key, and then press the
key while is shown on the display).
Note: If you exit the CONFIG screen by pressing the key, the changed
settings are canceled.
CLR
SKIP
ENT
TF
F
ENT
TF
ENT
TF
ENT
TF
ENT
TF
HELP
SET
F
M
O
D
E
AUTO MW
MIC
CTCSS
A-B S
M NAME
S
T
E
P
A
T
T
S
E
T
P
O
W
E
R
P
M
S
V
F
O
M
R
M
W
A
B
SET
K
L
3
6
5
2
1
4
SCN
RF C
HELP
MONI
F
SRCH
LAMP
SQL VOL
DOWN UP
O
N
O
FF
DI
R
ECT
W
R