Instruction manual
43
3
Select a scanning option.
Point the arrow at the desired option using the dial or UP/DOWN key, and then
press the key. The available scanning options are described below (the
initial setting is BUSY):
BUSY Busy scan. The DJ-X2000 stays on any signal it locates until
the signal vanishes. Once the signal disappears, scanning is
resumed.
STOP The DJ-X2000 stops scanning on the first signal it locates.
Scanning is not resumed after the signal vanishes.
TIMER When the currently transmitted signals of any frequency are
received, scanning is paused for a given period of time. After
this specific time period, scanning is resumed even if the
signals are being received. For setting the pause period, see
“3.1.17 Setting the scanning pause period” (page 44).
The display will return to the SCAN menu. Point the arrow at END using the dial
or UP/DOWN key, and then press the key (Alternatively, you may press the
key, and then press the key while is shown on the display).
Note: If you exit the SCAN menu by pressing the menu, the changed setting
is canceled.
3.1.16 Setting scan signal level
This setting specifies the minimum signal level used in scanning. Scanning will
stop only when the DJ-X2000 locates a signal of this strength or stronger.
1
Call up the SCAN menu.
Press the key, and then press
the key while is shown
on the display.
The MENU will appear. Point the
arrow at +CONFIG using the dial or UP/DOWN key, and
then press the key.
The CONFIG menu will appear. Point the arrow at
+SCAN and then press the key.
The SCAN menu will appear.
2
Call up the S_LEVEL screen.
Point the arrow to +S_LEVEL using the dial or the
UP/DOWN key, and then press the key.
The S_LEVEL screen will appear.
ENT
TF
ENT
TF
ENT
TF
HELP
SET
M
O
D
E
AUTO MW
MIC
A-B S
M NAME
S
T
E
P
A
T
T
S
E
T
P
O
W
E
R
P
M
S
V
F
O
M
R
M
W
A
B
SET
K
L
3
6
2
1
RF C
HELP
MONI
F
SRCH
LAMP
SQL VOL
DOWN UP
CLR
SKIP
ENT
TF
ENT
TF
ENT
TF
SCAN M
O
DE
BUSY T i me r
SCAN
S
O
FF
O
N1
LEVEL
F