Instruction manual

37
Note: • The cloning procedure or communication with a personal computer is not
possible between DJ-X2000 units with different communication speeds.
• The initial value is a high speed of 38400 bps. If there are too many
communication errors at this speed, retry the communication at a lower
speed, e.g., 9600 bps.
3.1.7 Selecting a language mode
The DJ-X2000 was set to the English mode at factory, but may be changed to
the Japanese mode.
1 Call up the LANGUAGE screen.
Press the key, and then press
the key while is shown on
the display.
The MENU will appear. Point the
arrow at +CONFIG using the dial or
UP/DOWN key, and then press the key.
The CONFIG menu will appear. Point the arrow at
+LANGUAGE and then press the key.
The LANGUAGE Screen will appear.
2 Select a language mode.
Point the arrow at English or Japanese using the dial or UP/DOWN key, and
then press the key (the initial setting is English).
The display will return to the CONFIG menu. Point the arrow at END and then
press the key (Alternatively, you may press the key, and then press
the key whi is shown on the display).
Note: If you exit the CONFIG menu by pressing the key, the changed setting
is canceled.
3.1.8 Field-strength meter
The level of the aperiodic field-strength meter can be set. When the electric field
strength reaches the set level, the buzzer sounds. This feature can be used,
e.g., to check for transmission from a bug.
The DJ-X2000 provides the following two modes to show electric field strength:
Meter display mode Shows changes in electric field strength using
the S-meter and beep sound.
Set level mode Starts sounding the buzzer when electric field
strength reaches the set level.
CLR
SKIP
F
ENT
TF
ENT
TF
ENT
TF
ENT
TF
HELP
SET
F
M
O
D
E
A
U
T
O
M
W
M
IC
A
-B
S
M
N
A
M
E
S
T
E
P
A
T
T
S
E
T
P
O
W
E
R
P
M
S
VFO
M
R M
W
A
B
SET
K
L

3
6
2
1
RF C
HELP
M
O
N
I
F
S
R
C
H
L
A
M
P
S
Q
L
V
O
L
D
O
W
N
U
P
ENT
TF
En
g
lish
Ja
p
anese
LANGUAGE
