Instruction manual

23
If live frequencies are received, scanning is temporarily stopped. To resume
scanning, turn the dial or press the UP/DOWN key. Scanning can be
automatically resumed by specifying scan resuming conditions. For further
details, see “3.1.15 Setting scan resume condition (SCAN MODE)” (page 42).
• To switch scanning direction
While scanning, press the DOWN key. The arrow icon will face right and
scanning will proceed toward the lower frequencies. To scan toward the higher
frequencies, press the UP key. The scanning direction can also be changed by
turning the dial.
• To cancel scanning
Press the key again.
2.8 Searching (Channel Scope™)
The search function, or Channel Scope of the DJ-X2000 checks frequencies in
the set frequency steps, and displays signals within a 40-channel or 7-channel
range at one time. The function is useful for checking the spectrum occupancy
at a glance. It is used as follows.
• 40-channel search
Press the key on the left side
panel. The DJ-X2000 will start
searching for signals within a 40-
channel range of the currently
received frequency. The search proceeds in set frequency
steps with the displayed frequency in the center under ▼
mark. The higher channel spectra are displayed towards
the right, and the lower to the left. Vertical length of each
spectrum indicates relative strength of the signals.
• 7-channel search
Press the key to display
Then, press the key on the left
side panel. The DJ-X2000 will start
searching for signals within a 7-
channel range of the currently received frequency. The
search proceeds in the set frequency steps with the
displayed frequency in the center under ▼ mark. The
higher channel spectra are displayed towards the right,
and the lower to the left. Vertical length of each spectrum
indicates strength of the signals.
SRCH
F
P
O
W
E
R
R
X
/
S
T
P
M
S
V
F
O
M
R
M
W
A
B
SET
MONI
F
SRCH
LAMP
SQL VOL
UP
SRCH
P
M
S
V
F
O
M
R
M
W
A
B
SET
MONI
F
SRCH
LAMP
SQL VOL
DOWN UP
SCN
A~B S
W
A81.5
b 145. 34
F
M
W
A81.5
b 145. 34
F
M