Instruction manual

33
8. Cloning
■ Transmitting the Master
Data
1. Press and hold the MONI key and
press the PTT key three times.
"CLONE" appears on the display to
indicate the Clone mode is activated.
2. Press the PTT key.
"Sd ✻✻✻" is displayed and
internal setting information is
transferred into the "slave"
transceiver.
"PASS" appears when the cloning
completes.
The same data is transmitted by
pressing the PTT key while the
"PASS" is displayed.
If the data is not transmitted correctly,
"PASS" is not displayed. Repeat from
procedure 1.
3. To cancel the Clone mode, switch the
power off.
Caution : If the cable is not connected correctly, "CHECK" appears on
the display.
Check the cable connection again.
Cloning Complete