User Manual

05-Jun-2007
Alinco XE972 User Manual Rev. 0.9
Page 7 of 9
3. Notes
FCC Statements:
This device complies with Part 15 of the FCC Rules.
Operation is subject to the following two conditions:
(1) this device may not cause harmful interference, and
(2) this device must accept any interference received,
including interference that may cause undesired
operation.
CHANGES OR MODIFICATIONS NOT EXPRESSLY APPROVED BY THE
MANUFACTURER FOR COMPLIANCE COULD VOID THE USER’S AUTHORITY
TO OPERATE THE EQUIPMENT
CAUTION: This device and its antenna(s) must not be co-
located or operating in conjunction with any
other antenna or transmitter. End user cannot
modify this transmitter device. Any unauthorized
modification made on the device could avoid the
user's authority to operate this device.
CAUTION: To comply with FCC RF exposure compliance
requirements, a separation distance of at least
20cm must be maintained between the antenna of
this device and all persons.
The following sentence has to be displayed on the outside
of the device in which the transmitter module is installed:
“Contains FCC ID:PH3XE972
This equipment has been tested and found to comply with the
limits for a Class B digital device, pursuant to part 15 of
the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a
residential installation. This equipment generates, uses
and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions, may
cause harmful interference to radio communications.