User's Manual

31
8
Cable Clone
Use optional CP53 cloning cable, connect the cable between the data jacks on both master and slave.
1.
Press and hold
2.
key to power on, then hold this key until the LCD displays "CLONE".
Press the dial,
3.
the Master unit and Slave unit both display "CLONE XX", "XX" stands for the data amount being cloned,
when the Master unit displays "CLONE" again, the Slave unit repower on, means the clone completed. Turn off the Slave
unit, and change another slave unit. Then repeat step 3 to clone next radio.
This feature will copy the programmed data and parameters from the master unit to slave units. It copies the parameters and memory program settings.
When the Master unit enter clone mode, repeater step 3 will be able to clone multi radios.
If the data is not successfully transmitted, turn off both units, make sure the cable connection is correct and repeat the entire operation from the beginning.
Clone Cable (CP-53)
N
OTE
RESUME FACTORY DEFAULT
If your radio seems to be malfunctioning becuase of wrong operation or setup, this function will be able to resume all setup and
channels to factory default.
Hold
key while power on the radio, all channnel and function setup will resume to factory default.