User's Manual

14
In standby, Press and while icon is displayed on the screen,
press key to enter Dual Watch mode. The radio will scan the
channel in every 5 seconds. When the radio receives matching signal, it
pause scanning until the signaling disappear. Repeat above operation to
exit Dual watch.
DUAL WATCH
EMERGENCY ALARM
To start emergency alarm, press and hold key until the trans
-ceiver displays ALARM and emit alarm. Re-power on the transceiver to
exit alarm. This transceiver has 4 kind of alarm which can be setup by
programming software.
In VFO mode, select the desired frequency by using the dial or
1.
numerical keys.
Press
2.
key to display and a memory channel number on the
display.
Rotate the dial or press
3.
[UP/DOWN] keys to select a desired
memory channel number.
While displaying the
4.
and a number, press key. MEN-IN
appears on the display. While it's displayed, press and hold the
key again until a beep is heard and MEN-IN dissapears. The memory
channel is set. If icon dissapears during operation, simply press
the key again to resume.
In VFO mode, press the or key to start scanning.
During the scanning, turn the dial or press [UP/DOWN] keys to change
the scanning direction. Press [PTT] or keys other than [UP/DOWN] to
stop scanning.
FREQUENCY SCAN
CHANNEL/FREQUENCY SCAN
CHANNEL SCAN
In Memory mode,press the or key to start scanning.
During the scanning,turn the dial or press [UP/DOWN] keys to change
the scanning direction. Press [PTT] or keys other than [UP/DOWN] to
stop scanning.
In Memory mode, turn the dial to choose the channel to skip during
scanning. Press and while icon is displayed on the screen,
press key. A beep sounds twice and the
channel is set as the skip channel and "P2"
icon. Repeat it to cancel the setting, a beep is
heard once and "P2" icon dissapears.
CHANNEL SCAN SKIP
MEMORY CHANNEL PROGRAMMING
SEARCH SCAN RANGE SETTING
Basic Operations
5
CTCSS/DCS Scan
In standby, long press key to enter CTCSS/DCS scan, when nd
matching CTCSS/DCS signal, the scan will pause in the scan pause
way. In the CTCSS/DCS Scan status, rotate band switch or press the
MIC UP/DOWN key can change the scan direction.
To enable this function, the channel shall be programmed with
CTCSS/DCS decode.
Five different search scan ranges are programmable.