User's Manual

key to choose output power from different levels. Every
13
Basic Operations
Transmitting
Transmit DTMF/2TONE/5TONE signaling
Frequency Reverse
CTCSS/DCS SETTING
Power SETTING
Before transmitting, monitor the frequnecy to make sure the channel is
vacant and won't cause interference to others.
Hold [PTT] key to transmit, and speak at
approximately 5cm/2 inces to the microphone
in normal voice level. Too loud or too silent
voice level may cause trouble hearing at the receiving stations.
If the current channel is with DTMF/2TONE/5TONE signaling, hold [PTT]
and [ UP ] key will transmit selected Pre-programmed signaling.
In standby, hold key for over 1 second to turn On/Off frequency
In standby, press key or microphone key can setting the
CTCSS/DCS encoding and decoding for current channel.
Press
1.
key, When the screen displays the CTCSS frequency
and " " icon, rotate band switch or MIC UP/DOWN keys to select
CTCSS encoding which is desired to setting, press key or [PTT]
key to conrm and exit.
Double Press
2.
key, When the screen displays the CTCSS
frequency and "
" icon, rotate band switch or MIC UP/DOWN
keys can sync setting the CTCSS encoding and decoding which is
desired, press
key or [PTT] key to conrm and exit
Press
3.
key three times, When the screen displays the DCS NO.
and "DCS" icon, rotate band switch or MIC UP/DOWN keys can sync
select the CTCSS encoding and decoding which is desired, press
key or [PTT] key to conrm and exit.
Press
press of the key toggles the setting as the chart below.
The setting is valid until next change in VFO mode, but it holds only
temporaly in the memory mode and changing the channel or turning
on/off the power will cancel the setting and recalls the original memory
parameter of the output power setting.
5
Transmitting is possible only on the MAIN band. Operating
setting can't be changed while transmitting.
This function is valid only when current channel setup with offset
frequency and offset direction
HIGH
VHF(50W)
UHF(40W)
reverse function. When reverse function is on, the TX frequency will
change to RX frequency and RX frequency change to TX frequency.
The signaling will also be reversed if CTCSS/DCS signaling existed in
this channel.
CALL CHANNEL RECALLING
Press key to recall a preprogrammed channel. It is convenient to
set the most frequently used channel in advance as a CALL channel for
quicker operation.Repeat it to return to the
last operating channel.