User's Manual
18
Turn Main Dial to select the desired
3.
setting .
On:In current channel,Press PTT to
transmit
OFF:In current channel,Press PTT is
invalid.
4
. Press
key to conrm and exit.
7
If LCD displays "
C*T",it indicates
you can hear the calling from caller
when receive a matching carrier and
CTCSS/DCS and DTMF/2TONE/5TONE signaling .
If LCD displays "
C/T",it indicates you
can hear the calling from caller when
receive a matching carrier and either
CTCSS/DCS DTMF/2TONE/5TONE
signaling.
Press
4.
key to conrm and exit.
Band-width Selection
Select suitable bandwidth in accordance with your local band-plans.
Press and hold
1.
key for over 2 seconds to enter setting menu.
Press
2.
/
key to choose No.08
menu, LCD displays"BAND--25".
Turn Main Dial to select the desired
3.
setting.
12:band width is 12.5KHz(Narrow band)
Press
4.
key to conrm and exit.
TX OFF SETUP
This function is to prohibit the transmission and to use the radio as a
receiver.
Press and hold
1.
key for over 2 seconds to enter setting menu.
Press
2.
/
key to choose No.09
menu, LCD displays"Tx-ON".
This function is available only for pre-programmed units with
Tone-signals and CTCSS/DCS selective calling.
PARAMETER SETTING MODE