User's Manual

16
Press
2.
/
key to choose No.01
menu, LCD displays ”STP--125”
Turn
3.
Main Dial to select the desired
frequency channel step.Available steps in KHz are: 2.5(shown as 2
K5),6.25(62),8.33(83),10,12.5(125),20,25,30 and 50.
Press
4.
key to conrm and exit
Press and hold
1.
key for over 2 seconds to enter setting menu.
Press and hold
1.
key for over 2 seconds to enter the parameter
setting mode.
Press
2.
or to select the desired menu.
Turn
3.
Main Dial to select the desired parameter.
Press
4.
to conrm and exit.
Only in VFO mode, this function is valid. Turn Main Dial to select
frequency step.
7
PARAMETER SETTING MODE
Frequency Step Setup
This function is not available in memory-mode.
DTMF, DTMF ANI, 2Tone or 5Tone Signaling
DTMF/5Tone/2Tone signalling are used for selective-calling. DTMF
and 5Tone signalling can be applied for other advanced features such
as ANI, PTT ID, group call, remotely stun,remotely kill, waken,...etc.
The signalling edition must be done in advanse to operatins through
programming software.
Press and hold
1.
key for over 2 seconds to enter into setting
menu.
Press
2.
/ to choose No 2 menu, LCD displays "T-OFF" .
Turn Main Dial to
3.
select the desired setup.
"DTMF”: the channel will be mute by a DTMF signal. The

speaker won’t sound until receiving
a correspondent DTMF signal. Hold
"PTT" then press [UP] directly to
transmit the pre-stored DTMF tones.
"2TONE": the channel will be mute by

a 2-Tone signal. The speaker won’t
sound until receiving a correspondent
2-Tone signal.Hold “PTT” then press
[UP] to transmit the pre-stored 2-Tone
signal.
"5Tone": the channel will be mute by

a 5-Tone signal. The Speaker won’t
sound until receiving a correspondent
5-Tone signal. hold [PTT] then press
[UP] directly to transmit the pre-stored
5-Tone signal.
Press
4.
key to conrm and exit.
IMPORTANT: All or a part of operation in this chapter may not be
available to dealer-programmed units.
The default setting list is available on P29.