User's Manual

12
Basic Operations
Transmitting Tone BURST TONE
Transmitting OPTIONAL SIGNALING
Press and hold [PTT] key, then press Microphone [
] key to
transmit current selected tone-burst tone. Pre-programming is necessary.
Press and hold [PTT] key, then press Microphone
key or press
key in front panel or press Mic's key to transmit pre-stored and
selected DTMF/2Tone/5Tone optional signaling. Pre-programming is
necessary.
MEMORY CHANNEL PROGRAMMING
MEMORY CHANNEL DELETING
Under frequency mode (VFO), turn
1.
Main Dial to select the desired
frequency or input frequency by MIC's numeric keys.
Press
2.
key to enter CTCSS/DCS signaling setup, turn Main Dial
to select the desired signaling. See P.13 for details.
Press
3.
key, LCD appears
, icon
and current channel number,
icon
ashing means current channel is empty.
Turn
4.
Main Dial to select the desired
channel number to store.
Press
5.
key, , icon and channel
number disappears and beep sounds
twice.
Press
6.
V/M key again to conrm that the memory channel is properly
stored.
Under Memory mode, turn
1.
Main Dial to select channel to be
deleted.
Press
2.
key and key together, current memory will be
deleted beep sounds.
icon ashing means current memory is
deleted.
5
While transmitting, LED lights RED and TX-meter shows relative power level.
Release PTT to receive.
Please hold the microphone approximately 2.5-5.0cm from your lips

, and
then speak into the microphone in your normal speaking voice.