User's Manual

3
2
Initial Installation

DC Power Cable Connection
Mobile Operation
The vehicle battery must have a nominal rating of 13.8V. Never
connect the transceiver to a 24V battery. Be sure to use a 13.8V
vehicle battery that has sufficient current capacity. If the current
to the transceiver is insufficient, the display may darken during
transmission, or transmitting output power may drop excessively.
1.
Route the DC power cable supplied with the transceiver directly
to the vehicle's battery terminals using the shortest path from the
transceiver.
▼
Never use the cigarette lighter socket as a DC source.
▼
The entire length of the cable must be dressed so it is isolated from
heat, moisture, and the engine secondary(high voltage) ignition
system/cables.
2.
After installing cable, in order to avoid the risk of damp, please use
heat-resistant tap to tie together with fuse box. Don't forget to rein-
force whole cable.
3.
In order to avoid the risk of short circuit, please cut down connec-
tion with negative (-) of battery, then connect with radio.
4.
Confirm the correct polarity of the connections, then attach the
power cable to the battery terminals; red connects to the positive (+)
terminal and black connects to the negative (-) terminal.
▼
Never remove the fuse holders from the cable.
5.
Reconnect any wiring removed from the negative terminal.
6.
Connect the DC power cable to the transceiver's power supply con-
nector.
▼
Press the connectors rmly together until the locking tab clicks.