User's Manual

28
7
PARAMETER SETTING MODE

SCANNING STOP TIME -BSY
From "Switching the Scanning Type ", select "Busy scan" to set the
duration time before switching to the next channel after stopping
receiving a signal.
1.
Rotate the push-button rotary knob or press the [UP]/[DOWN] keys
on the microphone to display the menu number "26".
The current setting will appear on the display.
The default setting is [ST-B.5] (5sec).
2.
Rotate the push-button rotary knob or press the [UP]/[DOWN] keys
on the microphone to change the setting.
The options are as follows.
▼
OFF (0sec) to 10 (10sec) (11 steps in 1 second increments)
3.
Press the push-button rotary knob.
The unit will go back to menu mode.

TONE SEARCH SCANNING SPEED
Set the scanning speed to search a tone frequency from the incoming
tone signal.
1.
Rotate the push-button rotary knob or press the [UP]/[DOWN] keys
on the microphone to display the menu number "27".
The current setting will appear on the display.
The default setting is [SS-T.FA].
2.
Rotate the push-button rotary knob or press the [UP]/[DOWN] keys
on the microphone to change the setting.
The options are as follows.
▼
FA: Searches fast.
▼
SLW: Searches slowly.
3.
Press the push-button rotary knob.
The unit will go back to menu mode.

DCS SCANNING SPEED
Set the scanning speed to search a DCS code from the incoming DCS
signal.
1.
Rotate the push-button rotary knob or press the [UP]/[DOWN] keys
on the microphone to display the menu number "28".
The current setting will appear on the display.
The default setting is [SS-D.FA].
2.
Rotate the push-button rotary knob or press the [UP]/[DOWN] keys
on the microphone to change the setting.
The options are as follows.
▼
FA: Searches fast.
▼
SLW: Searches slowly.
3.
Press the push-button rotary knob.
The unit will go back to menu mode.

PRIORITY SCAN SETTING
Set whether or not to check every 5 seconds whether the priority channel
receives a signal or not.
1.
Rotate the push-button rotary knob or press the [UP]/[DOWN] keys
on the microphone to display the menu number "29".
The current setting will appear on the display.
The default setting is [PRISOFF].