User Manual
46
Useful functions
&DEOHFORQHIXQFWLRQ
This feature will copy the programmed data and parameters in the master unit to slave units.
Connection
Make a cable using 3.5 mm stereo-mini plugs as
shown. Make a master unit by setting and programming
it as desired. Turn off both units. Connect the cable
between the DATA jacks (SP1) on both master and
slave. Turn both radios on after the connection is made.
IMPORTANT
Be certain to connect cables while the units are turned OFF.
stereo-mini plug
Slave SideMaster Side
Setting on the Master side
1. Press the FUNC key and then press MW
key while [FUNC] appears on the display.
[CLONE SD0000] will be displayed and
the radio enters the clone mode.
2. Press PTT. [CLONE SD****] will be
displayed and the master unit start
sending data to the slave unit.
**** will change during data transferring.
3. [CLONE PASS] will appear on the display
when the data has been successfully
transmitted.
4. The master radio may stay turned on for
the next clone. Turn off the unit to exit
from the clone mode.
Plug configuration
(both for Master/Slave)
During transmission
When transmission is finished