User Manual

38
Useful functions
3URJUDP6FDQ
This is a type of VFO scan, which is done by setting the frequency range of the VFO into the
P{A and P{B channels, it only scans between those frequencies. Each band can be set for
5 pairs. This program scan will operate under VFO setting, regardless of memory setting for
step or P{A/B memory setting.
P1A P1B
Air-Band VHF UHF
P2A P2B P3B P4AP3A P4B P5A P5B
1. Enter the VFO mode and set the P{A and
P{B frequencies into the designated
memory channels. Refer to Memory
setting for the proper sequence.
2. Return to the VFO mode by pressing V/M
key. Set the VFO to the frequency within
the range to be program-scanned.
3. Press the dial knob after pressing FUNC
key while [FUNC] appears on the display.
[PS] will appear on the display.
4. Rotate the dial or UP/DOWN keys on the
microphone to select pair number. Press
the dial to start scanning.
5. Press any key (other than the UP/DOWN
keys) to exit.
3ULRULW\6FDQ
This function allows 5 seconds scan of the user selected priority frequency and other
frequency in the VFO or memory modes. Scan will stop for 0.5 seconds when signal received
on main frequency and 2 seconds when signal received on priority frequency.
1. Use the cloning software to program
frequency. For details please refer to
cloning software instruction manual.
2. To start priority scanning, press dial knob
while pressing FUNC key. To stop
scanning press any key on desired side
or press PTT switch. [S] icon will be
disappeared.
Program Scan is going