User Manual

8
Initial Installation
IMPORTANT
DC voltage range for operating this transceiver is DC 11.7V to 15.8V.
Transceiver will not operate out of this range. Inspect cable and connection
regularly to be sure there is not any damage or burning.
DC power cable
DC
power
supply
Black
lead
Red
lead
)RUPRELOHVWDWLRQVHWXS
/RFDWLRQ
The transceiver may be installed in any position in
your vehicle, where the controls and microphones
are easily accessible and it does not interference
with the safe operation of the vehicle or the
performance of the set. If your vehicle is equipped
with air bag, be certain your radio will not
interference with their deployment. If you are uncertain about where to mount the unit, contact
your vehicle’s manufacture.
)URQW3DQHO
The main unit can be set with either side facing up. This can facilitate your ability to hear the
speaker’s audio clearly. Position the front panel as you prefer.
1. Slide the front panel while pulling the tab
toward yourself.
2. Turn the front panel, being careful to keep
the cable free from kinks.
3. Match the catch in the main unit with the
slot in the front panel and fit the front
panel into the main unit.
4. Slide the front panel unit until it locks
securely in place.