User's Manual
Table Of Contents
- Before operating the transceiver
- Attention
- _
- New and Innovative Features
- Standard Accessories
- _
- For a base station set up
- For a mobile station set up
- Location
- _
- Installing a Mobile Antenna
- Installing the Transceiver
- Front Panel
- External power control function
- Power supply voltage display function
- Part Names and Functions
- Front Panel
- Rear Panel
- Display
- Microphone EMS-53 (Standard)
- _
- Turning the unit on and off
- Switching the MAIN band
- Audio Volume level setting
- Changing frequency by channel step
- Changing frequency by 1 MHz step
- Setting the channel step
- Shift Direction and Offset frequency setting
- Memory Mode
- Recalling a memory channel
- Memory channel deleting
- Programmable data in the memory channel
- Channel name (Alphanumeric) registration function
- CALL mode
- To recall a CALL channel
- To receive signals
- Monitor function
- Reverse function
- To transmit
- Selecting transmission power
XBR (Crossband Repeater) Mode (for the DR-635T Only)
This mode allows the DR-635T to operate like a repeater using both VHF and UHF bands. That
is, when receiving a signal on one band, the DR635T automatically transmits the same signal on
another band simultaneously.
△
!
Notes:
･
The MAIN band setting cannot be altered in XBR mode.
･
Any combination of VFO, memory, or CALL channels can be set as
receiving and transmitting frequencies of the XBR as far as they are V/UHF
combination within the transmitter’s coverage.
･
The XBR doesn’t support digital modes such as packet and digital-voice.
･
The Tone-Squelch feature supports the XBR mode to filter unwanted
signals, however, the DCS feature doesn’t.
･
The XBR respects the offset direction and range settings of the transceiver
mode.
･
The TOT function is usable but TOT penalty-time and BCLO functions
become deactivated during the XBR operation.
Accessing or exiting the XBR Mode
Turn the power on while holding the BAND key pressed.
★ and
Ｒ icons appear on the screen. Repeat the same sequence to exit from the XBR mode.
End of document / PF0104