User's Manual
Table Of Contents
- Before operating the transceiver
- Attention
- _
- New and Innovative Features
- Standard Accessories
- _
- For a base station set up
- For a mobile station set up
- Location
- _
- Installing a Mobile Antenna
- Installing the Transceiver
- Front Panel
- External power control function
- Power supply voltage display function
- Part Names and Functions
- Front Panel
- Rear Panel
- Display
- Microphone EMS-53 (Standard)
- _
- Turning the unit on and off
- Switching the MAIN band
- Audio Volume level setting
- Changing frequency by channel step
- Changing frequency by 1 MHz step
- Setting the channel step
- Shift Direction and Offset frequency setting
- Memory Mode
- Recalling a memory channel
- Memory channel deleting
- Programmable data in the memory channel
- Channel name (Alphanumeric) registration function
- CALL mode
- To recall a CALL channel
- To receive signals
- Monitor function
- Reverse function
- To transmit
- Selecting transmission power
DC power cable
Transceiver
Battery
Steering wheel of the car.
45
To connect, set and operate
Special Functions
IMPORTANT: Be sure to connect the power cable directly to the car battery. The power cable of
this unit requires voltage at all times to activate this function.
For the same reason, the ACC ON/OFF feature must be deactivated.
THEFT ALARM
This alert uses a beep sound when the unit is about to be removed in an improper manner. This
function is useful when the unit is installed in a vehicle.
1. Wire the alarm cable (There are 2 ways to con-
figure).
1. Modifying and inserting a 3.5 Ø stereo plug
for the alarm into the SP terminal jack in
the back, as the figure shows.
This configuration is recommended for ve-
hicle installation, for easier removal of the
cable
2. Modifying and inserting the provided wir-
ing cable UX1290A into the connecter
CN10 in the unit.
This configuration is recommended for a
semi-permanent installation. By selecting
this configuration the speaker remains ac-
tive, either internal or external, as config-
ured.
3.5 Ø stereo plug: Looped
UX1290A: Extended and looped
Connect and loop the red and black lead.
Black Red
CN10
Ensure the tube of the
cable goes through the
slot on the chassis.
2. Be sure to fix the alarm cable to the steer-
ing wheel. As the figure shows.