User's Manual
Table Of Contents
- Before operating the transceiver
- Attention
- _
- New and Innovative Features
- Standard Accessories
- _
- For a base station set up
- For a mobile station set up
- Location
- _
- Installing a Mobile Antenna
- Installing the Transceiver
- Front Panel
- External power control function
- Power supply voltage display function
- Part Names and Functions
- Front Panel
- Rear Panel
- Display
- Microphone EMS-53 (Standard)
- _
- Turning the unit on and off
- Switching the MAIN band
- Audio Volume level setting
- Changing frequency by channel step
- Changing frequency by 1 MHz step
- Setting the channel step
- Shift Direction and Offset frequency setting
- Memory Mode
- Recalling a memory channel
- Memory channel deleting
- Programmable data in the memory channel
- Channel name (Alphanumeric) registration function
- CALL mode
- To recall a CALL channel
- To receive signals
- Monitor function
- Reverse function
- To transmit
- Selecting transmission power
40
Useful functions
•DCS scan
Same as previous, but for DCS code search.
1. While in the DCS setting, press the UP/DOWN
key for more than 1 second but less than 2 sec-
onds to start scanning.
(It scans 105 DCS codes in order.)
• During scanning, the 1 MHz order decimal
point will flash.
• The scan stops when the matching DCS code
is detected and reception starts.
2. When scanning has finished, pressing any key
other than the UP/DOWN key will cancel the
scan mode.
DCS
KEY-LOCK FUNCTION
This will lock the keys to avoid unintentional changes.
1. Press FUNC key and press the TS/DCS key
while the F is on the display.
2. The [
] icon appears.
3. With this function activated, only the follow-
ing commands can be accessed:
• PTT
• FUNC+TS/DCS to cancel this function
•Monitor function (to release squelch for weak
signal reception)
• Squelch setting
•Volume setting
TONE BURST
This feature is to alert the other party by adding a tone to the transmitted signal.
• When the PTT key and the DOWN key are pressed together, a tone signal is transmitted.
• The default is an alert sound. The transmitted tone can be changed in the Setting mode.
• For the DR-635E, a 1750Hz tone burst signal is transmitted as the default setting, so that a
repeater can be accessed by the tone.
IMPORTANT: After scanning stops, it will not resume until the dials moved or the Mic
UP/DOWN key is pressed.