User's Manual
Table Of Contents
- Before operating the transceiver
- Attention
- _
- New and Innovative Features
- Standard Accessories
- _
- For a base station set up
- For a mobile station set up
- Location
- _
- Installing a Mobile Antenna
- Installing the Transceiver
- Front Panel
- External power control function
- Power supply voltage display function
- Part Names and Functions
- Front Panel
- Rear Panel
- Display
- Microphone EMS-53 (Standard)
- _
- Turning the unit on and off
- Switching the MAIN band
- Audio Volume level setting
- Changing frequency by channel step
- Changing frequency by 1 MHz step
- Setting the channel step
- Shift Direction and Offset frequency setting
- Memory Mode
- Recalling a memory channel
- Memory channel deleting
- Programmable data in the memory channel
- Channel name (Alphanumeric) registration function
- CALL mode
- To recall a CALL channel
- To receive signals
- Monitor function
- Reverse function
- To transmit
- Selecting transmission power
20
Basic Operations
How to program memory channel (s)
1. Select a frequency to be programmed in the
VFO mode and set the parameters as appropri-
ate. Refer to the next page for programmable
parameters.
2. By pressing FUNC key, [F] and [Memory No.]
icons will appear on the display.
3. Rotate the main dial (or press Mic UP/DOWN
key) to select the desired memory channel num-
ber.
4. An empty channel is shown with a flashing
[Memory No.] icon.
5. By pressing V/M key while [F]icon is on the
display, programming will be completed and
you will hear a beep sound.
6. If a previously programmed channel is selected
in step 3, the memory channel will be over-
written by executing the procedure in step 5.
7. When CH-C is selected, the CALL channel will
also be rewritten.
During the unregistered channel
IMPORTANT: • Program the Theft-Alarm frequency in CH99.
• For Channels from 100 to 139, the VHF/UHF band can be programmed indis-
criminately (VHF/UHF mixed scanning is possible by memory program scan-
ning.).
• The memory channels can’t be edited (programing/deleting) while SUB icon
appears on the display. Please change the sub-band frequency to turn it off.