User's Manual
Table Of Contents
- Before operating the transceiver
- Attention
- _
- New and Innovative Features
- Standard Accessories
- _
- For a base station set up
- For a mobile station set up
- Location
- _
- Installing a Mobile Antenna
- Installing the Transceiver
- Front Panel
- External power control function
- Power supply voltage display function
- Part Names and Functions
- Front Panel
- Rear Panel
- Display
- Microphone EMS-53 (Standard)
- _
- Turning the unit on and off
- Switching the MAIN band
- Audio Volume level setting
- Changing frequency by channel step
- Changing frequency by 1 MHz step
- Setting the channel step
- Shift Direction and Offset frequency setting
- Memory Mode
- Recalling a memory channel
- Memory channel deleting
- Programmable data in the memory channel
- Channel name (Alphanumeric) registration function
- CALL mode
- To recall a CALL channel
- To receive signals
- Monitor function
- Reverse function
- To transmit
- Selecting transmission power
17
Basic Operations
Setting the channel step
1. When the unit is in VFO mode, enter into the
SET mode and select the channel step setting
display. (Refer to page 26 to 28 for SET mode).
2. The current channel step will be displayed.
3. You can change the channel step as below by
rotating the dial.
4. Pressing any key other than the FUNC key or
SQL key on the unit will complete the setting
and the display will return to the original sta-
tus.
Channel step setting display (default)
STEP 5
(5 kHz)
STEP 50
(50 kHz)
STEP 100
(100 kHz)
STEP 30
(30 kHz)
STEP 25
(25 kHz)
STEP 20
(20 kHz)
STEP 8.33
(8.33 kHz)
STEP 10
(10 kHz)
STEP 12.5
(12.5 kHz)
STEP 15
(15 kHz)
IMPORTANT: By changing the channel step frequency, settings below 10kHz may be auto-
matically corrected.