User's Manual
Table Of Contents
- DR-635 User Manual.pdf
- Before operating the transceiver
- Attention
- _
- New and Innovative Features
- Standard Accessories
- _
- For a base station set up
- For a mobile station set up
- Location
- _
- Installing a Mobile Antenna
- Installing the Transceiver
- Front Panel
- External power control function
- Power supply voltage display function
- Part Names and Functions
- Front Panel
- Rear Panel
- Display
- Microphone EMS-53 (Standard)
- _
- Turning the unit on and off
- Switching the MAIN band
- Audio Volume level setting
- Changing frequency by channel step
- Changing frequency by 1 MHz step
- Setting the channel step
- Shift Direction and Offset frequency setting
- Memory Mode
- Recalling a memory channel
- Memory channel deleting
- Programmable data in the memory channel
- Channel name (Alphanumeric) registration function
- CALL mode
- To recall a CALL channel
- To receive signals
- Monitor function
- Reverse function
- To transmit
- Selecting transmission power
53
Special Functions
APRS operation
For detailed information, please see a list of commands and
the instruction manual of the EJ-50U.
1. Boot up the terminal software on the PC, press
the FUNC key and press the H/L key while the
[F] icon is on. [TNC] lights up on the display
and the unit enters Geolocating communication
mode.
2. The initial screen of the TNC appears on the
PC.
3. Set communication speed of the packets from
the command mode (cmd:).
[Example cmd: HB 1200 or 9600]
4. Register the call sign of your station.
[Example cmd: MY *****]
5. Set the communication speed of the GPS port.
[Example cmd: GB 4800]
6. Set the automatic transmission time interval.
[Example cmd: LOC E 3]
7. When the location data etc. is received from
the GPS receiver, it will be automatically trans-
mitted as programmed.
8. By pressing the FUNC key and then the H/L
key, the TNC will be turned off and transmis-
sion of position data will be stopped.
9. By turning the TNC on again, automatic trans-
mission will resume following the previous set-
tings.
IMPORTANT: • While using APRS software, the header setting for monitoring should be OFF.
(Input: cmd: LTMH OFF)
• Please use this unit and the GPS receiver reasonably apart from each other.
TASCO Radio Modem
AX.25 Level 2 Version 2.0
Release 03/Dec/99 3Chip ver 1.08
Checksum $04
cmd:HB 1200
HBAUD was 1200
cmd:MY JA1234
MYCALL was NOCALL
cmd:GB 4800
GBAUD was 4800
cmd:LOC E 6
LOCATION was EVERY 0
cmd:
TNC
Example of PC display
Geolocating communication mode