User's Manual
Table Of Contents
- DR-635 User Manual.pdf
- Before operating the transceiver
- Attention
- _
- New and Innovative Features
- Standard Accessories
- _
- For a base station set up
- For a mobile station set up
- Location
- _
- Installing a Mobile Antenna
- Installing the Transceiver
- Front Panel
- External power control function
- Power supply voltage display function
- Part Names and Functions
- Front Panel
- Rear Panel
- Display
- Microphone EMS-53 (Standard)
- _
- Turning the unit on and off
- Switching the MAIN band
- Audio Volume level setting
- Changing frequency by channel step
- Changing frequency by 1 MHz step
- Setting the channel step
- Shift Direction and Offset frequency setting
- Memory Mode
- Recalling a memory channel
- Memory channel deleting
- Programmable data in the memory channel
- Channel name (Alphanumeric) registration function
- CALL mode
- To recall a CALL channel
- To receive signals
- Monitor function
- Reverse function
- To transmit
- Selecting transmission power
47
Special Functions
Setting alarm starting time
Choose this operation when a delay period is desired.
1. Enter the Parameter setting mode as described
previously and select SCR-DLY. Follow the
previous instruction to set.
2. Turn off the unit. Display will disappear but
the LCD illumination stays on. After 20 sec-
onds, the TX LED lights up, illumination dims,
and the alarm functions. The system won’t work
during the 20 second “DELAY” period.
3. The alarm sounds under the same condition as
described previously. There is a 20 second de-
lay until the alarm sounds. During the 20 sec-
ond period, only the display illumination is lit.
Turn ON the unit with the SQL key pressed
during the “DELAY” period to cancel the alarm
function.
IMPORTANT: Please set the parameters at SCR-OFF during normal operation.
NOTE: Please use a sticker provided indicating installation of the theft alarm device.
TX lamp