User's Manual
Table Of Contents
- DR-635 User Manual.pdf
- Before operating the transceiver
- Attention
- _
- New and Innovative Features
- Standard Accessories
- _
- For a base station set up
- For a mobile station set up
- Location
- _
- Installing a Mobile Antenna
- Installing the Transceiver
- Front Panel
- External power control function
- Power supply voltage display function
- Part Names and Functions
- Front Panel
- Rear Panel
- Display
- Microphone EMS-53 (Standard)
- _
- Turning the unit on and off
- Switching the MAIN band
- Audio Volume level setting
- Changing frequency by channel step
- Changing frequency by 1 MHz step
- Setting the channel step
- Shift Direction and Offset frequency setting
- Memory Mode
- Recalling a memory channel
- Memory channel deleting
- Programmable data in the memory channel
- Channel name (Alphanumeric) registration function
- CALL mode
- To recall a CALL channel
- To receive signals
- Monitor function
- Reverse function
- To transmit
- Selecting transmission power
28
Parameter Setting Mode
Channel Step setting
This is to select the channel step to be used in the VFO mode.
Refer to the chart below for the sequence of the actual steps
and how they are displayed.
Scan Type
This is to select the scan resume condition. The TIMER set-
ting allows the radio to resume scanning after 5 seconds, re-
gardless of the signal receiving status. The BUSY setting re-
sumes scanning when the received signal is gone. The scan
mode is explained later.
Beep Sound
This is to change the volume of a beep sound during operation.
1. The [BEEP2] icon appears on the display.
2. By rotating the dial, the display will change as
below and the volume of the beep sound will
be changed.
STEP 5
(5 kHz)
STEP 50
(50 kHz)
STEP 100
(100 kHz)
STEP 30
(30 kHz)
STEP 25
(25 kHz)
STEP 20
(20 kHz)
STEP 8.33
(8.33 kHz)
STEP 10
(10 kHz)
STEP 12.5
(12.5 kHz)
STEP 15
(15 kHz)
BUSY TIMER
Volume low
BEEP 1 BEEP 2
Volume High
BEEP 3
Volume 0
BEEP OFF
NOTE: The default is as follows.
• DR-635E [STEP 12.5]
• DR-635T [STEP 5]
(Refer page 27 for how to enter the setting mode.)