User's Manual
Table Of Contents
- DR-635 User Manual.pdf
- Before operating the transceiver
- Attention
- _
- New and Innovative Features
- Standard Accessories
- _
- For a base station set up
- For a mobile station set up
- Location
- _
- Installing a Mobile Antenna
- Installing the Transceiver
- Front Panel
- External power control function
- Power supply voltage display function
- Part Names and Functions
- Front Panel
- Rear Panel
- Display
- Microphone EMS-53 (Standard)
- _
- Turning the unit on and off
- Switching the MAIN band
- Audio Volume level setting
- Changing frequency by channel step
- Changing frequency by 1 MHz step
- Setting the channel step
- Shift Direction and Offset frequency setting
- Memory Mode
- Recalling a memory channel
- Memory channel deleting
- Programmable data in the memory channel
- Channel name (Alphanumeric) registration function
- CALL mode
- To recall a CALL channel
- To receive signals
- Monitor function
- Reverse function
- To transmit
- Selecting transmission power
22
Basic Operations
Channel name (Alphanumeric) registration function
The memory channels stored in the memory mode can be displayed with an alphanumeric tag
instead of the default frequency display. There are 67 characters available including A-Z, 0-9.
1. In the memory mode, select a channel to be
programmed.
2. Press the H/L key together with the FUNC key.
3. The display shows [A ] flashing.
4. Rotate the dial to select a character to be pro-
grammed.
5. By pressing the BAND key, the character stops
flashing and is entered.
An identical character to the one just entered
flashes on the immediate right ready to be ed-
ited.
6. Enter the next character with the BAND key.
(Repeat the same sequence)
7. Pressing the CALL key during programming
will delete all characters to be programmed.
8. Pressing any key other than the BAND key and
the CALL key will complete the setting and the
display will return to the original status.
NOTE: In the memory mode, a designated alphanumeric tag is displayed instead of the frequency
for a channel with a designated channel name (CH number is displayed unchanged). By
pressing the FUNC key for 5 seconds, the frequency will be displayed.
(By pressing any key during operation, the display will return to show the channel name.
But by operating a key designated for some FUNC key, the unit will enter the designated
setting mode.)