User's Manual
Table Of Contents
- DR-635 User Manual.pdf
- Before operating the transceiver
- Attention
- _
- New and Innovative Features
- Standard Accessories
- _
- For a base station set up
- For a mobile station set up
- Location
- _
- Installing a Mobile Antenna
- Installing the Transceiver
- Front Panel
- External power control function
- Power supply voltage display function
- Part Names and Functions
- Front Panel
- Rear Panel
- Display
- Microphone EMS-53 (Standard)
- _
- Turning the unit on and off
- Switching the MAIN band
- Audio Volume level setting
- Changing frequency by channel step
- Changing frequency by 1 MHz step
- Setting the channel step
- Shift Direction and Offset frequency setting
- Memory Mode
- Recalling a memory channel
- Memory channel deleting
- Programmable data in the memory channel
- Channel name (Alphanumeric) registration function
- CALL mode
- To recall a CALL channel
- To receive signals
- Monitor function
- Reverse function
- To transmit
- Selecting transmission power
21
Basic Operations
Programmable data in the memory channel
Each Memory channel including 00 – 99, 100 – 39, CALL channel and AL, AH, PL, PH channel
can store following:
• Frequency
• Shift frequency
• Shift direction (+ / -)
• Tone encoder frequency
• Tone decoder frequency
• Tone encoder/decoder setting
• DCS encoder code
• DCS decoder code
• DCS setting
• Skip CH setting
• Busy channel Lock Out (BCLO)
• Digital mode setting
• Digital code
• Narrow mode setting
• AM mode setting
• Clock shift setting
Memory channel deleting
1. Select the memory mode by pressing the V/M
key.
2. Select the desired memory channel number by
rotating the main dial.
3. The programmed memory channel has the
memory number illuminated on the display.
4. By pressing the M/W key together with the
FUNC key while [F] icon is on, a beep will
sound and the memory will be deleted. At the
same time, [Memory No.] icon will start flash-
ing.
NOTE: When an LCD memory channel is flashing, the full contents of the memory are
displayed in the LCD.
After pressing FUNC key again, if you press M/W key while [F] icon is on, you can
restore a deleted memory. However, after changing CH or the mode, restoration
will not be possible.
Memory Mode