User's Manual
Table Of Contents
- DR-635 User Manual.pdf
- Before operating the transceiver
- Attention
- _
- New and Innovative Features
- Standard Accessories
- _
- For a base station set up
- For a mobile station set up
- Location
- _
- Installing a Mobile Antenna
- Installing the Transceiver
- Front Panel
- External power control function
- Power supply voltage display function
- Part Names and Functions
- Front Panel
- Rear Panel
- Display
- Microphone EMS-53 (Standard)
- _
- Turning the unit on and off
- Switching the MAIN band
- Audio Volume level setting
- Changing frequency by channel step
- Changing frequency by 1 MHz step
- Setting the channel step
- Shift Direction and Offset frequency setting
- Memory Mode
- Recalling a memory channel
- Memory channel deleting
- Programmable data in the memory channel
- Channel name (Alphanumeric) registration function
- CALL mode
- To recall a CALL channel
- To receive signals
- Monitor function
- Reverse function
- To transmit
- Selecting transmission power
19
Basic Operations
Memory Mode
This mode allows recalling and operating the preprogrammed frequency or setting. This unit pro-
vides up to 200 memory channels (80 exclusive channels each for VHF and UHF, from 00 to 79CH
and 40 common channels for VHF and UHF, from 100 to 139), 1 CALL channel each for V and U
(C), 1 program-scan edge memory channel each for V and U (PL) (PH) and 1 VFO automatic
Memory mode
Memory channel
In case the SUB side is in the memory mode
program setting channel (AL) (AH).
Recalling a memory channel
1. Select the memory mode by pressing V/M key.
[00] appears on the display to indicate that the
unit is in the memory mode.
Repeat to switch between memory and VFO.
2. Select a memory channel.
Rotating the main dial (or by pressing the UP/
DOWN Mic keys) will increase or decrease a
memory channel number by 1 channel step. For
recalling a memory on the SUB band, first
switch the MAIN band by pressing the BAND
key. When the SUB side is in the memory mode
or CALL mode, [
] appears on the display.
When recalling any memory number between
100 and 139, the display on the SUB side will
disappear.
IMPORTANT: If memory channels have not been programmed, the unit will not be
switched to the memory mode by pressing V/M key. Please read memory
channel programming on the next page.