User's Manual
Table Of Contents
- DR-635 User Manual.pdf
- Before operating the transceiver
- Attention
- _
- New and Innovative Features
- Standard Accessories
- _
- For a base station set up
- For a mobile station set up
- Location
- _
- Installing a Mobile Antenna
- Installing the Transceiver
- Front Panel
- External power control function
- Power supply voltage display function
- Part Names and Functions
- Front Panel
- Rear Panel
- Display
- Microphone EMS-53 (Standard)
- _
- Turning the unit on and off
- Switching the MAIN band
- Audio Volume level setting
- Changing frequency by channel step
- Changing frequency by 1 MHz step
- Setting the channel step
- Shift Direction and Offset frequency setting
- Memory Mode
- Recalling a memory channel
- Memory channel deleting
- Programmable data in the memory channel
- Channel name (Alphanumeric) registration function
- CALL mode
- To recall a CALL channel
- To receive signals
- Monitor function
- Reverse function
- To transmit
- Selecting transmission power
7
Initial Installation
For a mobile station set up
Location
The transceiver may be installed in any position in your car, where the controls and microphone are
easily accessible and it does not interfere with the safe operation of the vehicle or the performance
of the set. If your vehicle is equipped with air bags, be certain your radio will not interfere with
their deployment. If you are uncertain about where to mount the unit, contact your vehicle's manu-
facturer. Please refer the next page for positioning the front control unit.
Installing a Mobile Antenna
Use a 50 ohm coaxial cable to connect the antenna. Mobile antennas require an appropriate mount-
ing base for proper installation and operation. For more information, see the documentation for
your antenna.
Installing the Transceiver
See the figures below.
b
a
a
b
IMPORTANT: After installing your antenna, ensure that you have the best possible SWR reading.
High RF environments can cause severe damage to your unit. Ensure that you are not
in a high RF environment when operating the transceiver.
*Use provided screws only(M4 x 8mm)
to fix the bracket. Irregular screws
may damage the circuit-board inside.