User's Manual Part 2

Useful functions

Single-band mode

This is to use the unit just like a single-band transceiver only for VHF or UHF, by erasing display on

the SUB side.

1. Press the BAND key while pressing and hold-

ing the FUNC key.

The display on the SUB side disappears and its

function is temporary suspended.

While in the V-V/U-U mode, the unit will not

enter to the single-band mode.

VFO Auto-program setting function

This is to program various automatic settings in a certain frequency range in the VFO mode.

It is useful for quick repeater access.

1. Program the lower edge frequency of the de-

sired range as well as other parameters such as

repeater shift, CTCSS tone into the [AL] chan-

nel in the memory mode (Refer page 19).

Programmable items are frequency, shift direc-

tion, offset frequency, tone ENC frequency and

its setting, tone DEC frequency and its setting,

DCSEN code and its setting, and DESDEC set-

ting.

2. As above program the higher edge frequency

in the [AH] channel of the memory. Disregard

other settings such as CTCSS tones or repeater

shift.

3. In the VFO mode, what have been programmed

in the AL memory are automatically set within

the frequency band between AL and AH.

Temporary setting change is possible between

AL and AH, but once frequency is changed by

rotating the dial, all the preset values in AL will

be restored.

When 439.000MHz 88.5Hz ENC-5.000MHZ

shift is set in AL

Shows an example within

VFO auto-program setting