User's Manual Part 2

52
Special Functions
For operation
For detailed information, please see a list of commands and
an instruction manual of EJ-50U.
1. Boot up the terminal software on the PC, press
the FUNC key and press the H/L key while [F]
icon is on. [TNC] lights up on the display and
the unit enters Geolocating communication
mode.
2. Initial screen of TNC appears on the PC.
3. Set communication speed of radio packet from
the command mode (cmd:).
[Example cmd: HB 1200 or 9600]
4. Register call sign of your station.
[Example cmd: MY *****]
5. Set communication speed of the GPS port.
[Example cmd: GB 4800]
6. Set automatic transmission time separation of
GPS data.
[Example cmd: LOC E 3]
7. When location data etc. is received from the
GPS receiver, it will be automatically transmit-
ted with a programmed time separation.
8. By pressing the FUNC key and then the H/L
key, TNC will be turned off and transmission
will also be stopped.
9. By turning on TNC again, automatic transmis-
sion will resume following the previous set-
tings.
IMPORTANT: • While using APRS software, header setting for monitoring should be OFF.
(Input: cmd: LTMH OFF)
• Please use this unit and a GPS receiver reasonably apart from each other.
TASCO Radio Modem
AX.25 Level 2 Version 2.0
Release 03/Dec/99 3Chip ver 1.08
Checksum $04
cmd:HB 1200
HBAUD was 1200
cmd:MY JA1234
MYCALL was NOCALL
cmd:GB 4800
GBAUD was 4800
cmd:LOC E 6
LOCATION was EVERY 0
cmd:
TNC
Example of PC display
Geolocating communication mode