Manualshelf

User's Manual Part 2

ManualsBrandsAlinco Incorporated, Electronics Division ManualsElectronicsAmateur Transceiver with Scanning Receiver
11121314151617181920
48
Special Functions
Setting on the Master side
1. Press CALL key with FUNK key pressed.
CLONE will be displayed and the radio enters
the clone mode.
2. Press PTT. SD*** will be displayed and it starts
sending the data into the slave unit.
3. [PASS] will appear on the display when the data
is successfully transmitted.
4. The master radio may stay turned on for the
next clone. Turn off the unit to exit from the
clone mode.
If the data is not successfully transmitted, turn off both units, make sure the cable connection is
correct and repeat the entire operation from the beginning.
IMPORTANT: Never pull off the cable while the data is transmitted in clone mode.
During transmission
When transmission is finished