User's Manual Part 2

Special Functions

Cable Clone

This feature will copy the programmed data and parameters in the master unit to slave units.

3.5 ø stereo-mini plug

Master side Slave side

Connection

Make a cable using 3.5 mm stereo-mini plugs as shown above. Make a master unit by setting and

programming it as desired. Turn off both units. Connect the cable between the DATA jacks on both

master and slave. Turn both radios on after the connection is made.

Plug configuration (both for Master/Slave)

GND

DATA

TX/RX

IMPORTANT: Be sure to connect cables while the unit is turned OFF.

Setting on the Slave side

1. Go to receive mode (VFO or Memory). Avoid

using 9600 bps data reception.

2. When it receives the clone data, LD*** shows

up on the display.

3. When the transmission is successfully finished,

the display will show [PASS].

4. Turn off the power. Disconnect the cable and

repeat the sequence to clone the next slave unit.