User's Manual Part 2

DC power cable

Transceiver

Battery

Handle of the car etc.

To connect, set and operate

Special Functions

IMPORTANT: Be sure to connect the power cable directly to a car battery. The power cable of this

unit requires voltage at all times to activate this function.

For the same reason, ACC ON/OFF feature must be deactivated.

THEFT ALARM

This alert uses a beep sound when the unit is about to be removed in an improper manner. This

function is useful when the unit is installed in a vehicle.

1. Wire the alarm cable (There are 2 ways to con-

figure).

1. Modifying and inserting 3.5 Ø stereo plug

for alarm into the SP terminal jack in the

back, as the figure shows.

This configuration is recommended for ve-

hicle installation for the easier removal of

the cable

2. Modifying and inserting the provided wir-

ing cable UX1290A into the connecter

CN10 in the unit.

This configuration is recommended for

semi-permanent setting. By selecting this

configuration speaker remains active, either

internal or external, as configured.

3.5 Ø stereo plug: Looped

UX1290A: Extended and looped

Connect and loop the red and black lead.

Black Red

CN10

Ensure the tube of the

cable goes through the

slot on the chassis.

2. Be sure to fix the alarm cable to a steering

etc. as the figure shows.