User's Manual Part 2

Useful functions

•DCS scan

Same as previous, but for DCS code search.

1. While in the DCS setting, press the UP/DOWN

key for more than 1 second but less than 2 sec-

onds to start scanning.

(It scans 105 DCS codes in order.)

• During scanning, 1 MHz order decimal point

will flash.

• The scan stops when the matching DCS code

is detected and reception starts.

2. After scanning is over, pressing any key other

than UP/DOWN key will cancel the scan mode.

DCS

KEY-LOCK FUNCTION

This will lock the keys to avoid unintentional changes.

1. Press FUNC key and press TS/DCS key while

F icon is on the display.

2. The [ ] icon appears.

3. With this function activated, only the follow-

ing commands can be accessed:

• PTT

• FUNC+TS/DCS to cancel this function

• Monitor function (to release squelch for weak

signal reception)

• Squelch setting

• UP/DOWN keys

TONE BURST

This feature is to recall the other party by adding a tone to the transmitting signal.

• While the PTT key and the DOWN key are pressed together, a tone signal is transmitted.

• The default is an alert sound. Transmitted tone can be changed in the Setting mode.

• For DR-620E, 1750Hz tone burst signal is transmitted as the default setting, so that a repeater

can be accessed to.

IMPORTANT: After scanning is over, it will not resume until another dialing or UP/

DOWN key pressing will be made.