User's Manual Part 1

ManualsBrandsAlinco Incorporated, Electronics Division ManualsElectronicsAmateur Transceiver with Scanning Receiver

Parameter Setting Mode

Channel Step setting

This is to select the channel step to be used in the VFO mode.

Refer to the chart below for the relation of the actual step

frequency and how it is displayed.

Scan Type

This is to select the scan resume condition. TIMER setting

allows the radio to resume scanning after 5 seconds, regard-

less of the signal receiving status. BUSY setting resumes scan-

ning when the received signal is gone. The scan mode is ex-

plained later.

Beep Sound

This is to change the volume of a beep sound during operation.

1. [BEEP2] icon appears on the display.

2. By rotating the dial, the display will change as

below and the volume of a beep sound will be

changed.

STEP 5

(5 kHz)

STEP 50

(50 kHz)

STEP 100

(100 kHz)

STEP 30

(30 kHz)

STEP 25

(25 kHz)

STEP 20

(20 kHz)

STEP 8.33

(8.33 kHz)

STEP 10

(10 kHz)

STEP 12.5

(12.5 kHz)

STEP 15

(15 kHz)

TIMER BUSY

Volume low

BEEP 1 BEEP 2

Volume High

BEEP 3

Volume 0

BEEP OFF

NOTE: The default is as follows.

• DR-620E [STEP 12.5]

• DR-620T [STEP 5]

(Refer page 27 for how to enter the setting mode.)