User's Manual

8. PACKET OPERATION

Packet Mode Setting

1. Press FUNC key. While F icon is on, press SQL key. [ ] appears on the LCD

display and the transceiver enters packet mode. Repeat the same sequence to exit

from packet mode.

2. Use the computer keyboard to send designated commands from your PC to enter the

packet network and start operation. Refer to the chart for TNC commands. Use the

commands to select between 1200/9600 bps data speed.

Reference:

The configuration of EJ-41U is as follows. Please use PC commands to program.

• Data Speed (Transfer Rate) 9600bps (to computer)

• Data Length 8 bit

• Parity Bit none

• Stop bit 1 bit

• Flow Control Xon/Xoff

Once the EJ-41U is programmed, the settings are stored in memory even if the unit

is removed from the transceiver. Some EJ-41U functions may be limited as com-

pared to those found in an external TNC.

VCO case

CN107

DSUB-9

Bottom side

3. Place the cushion sticker on the VCO shield case (a metal housing on the circuit

board).

CAUTION:

In order to replace a lithium-Ion battery installed on EJ-41U, please be mindful to the

polarity of the battery. If it is replaced in wrong way, it may cause damages to the EJ-

41U and/or the radio risking even the explotion of components. A soldering iron is

required for the task and if you are not confident, please consult with your local

Alinco dealer for the replacement.

EJ-4 1U (option)