User Manual

9
■
Loading the Batteries
Load three AA batteries in the battery
case in the "+" and "-" orientation
marked at the bottom of the case.
Caution!
· Do not use NiCad AA batteries on the market.
· Use new batteries of the same type and brand.
· Use high capacity of alkaline batteries.
■
The NiMH Battery Pack
Caution!
· The battery pack is not charged when shipped.
It must be charged before use.
· It takes 10 hours maximum to fully charge the
battery pack with the EDC-105.
· Charging should be conducted in a temperature range of 0 to 40°C. (32 to
104°F)
· Do not modify, dismantle, incinerate or immerse the battery pack in the
water as this can be dangerous.
· Never short-circuit the battery pack terminals, as this can cause damage
to the equipment or lead to heating of the battery which may cause burns.
· Unnecessary prolonged charging (overcharging) can deteriorate battery
performance.
· The battery pack should be stored in dry place where temperature is from
-20 to +45°C. (-4 to +113°F)
Temperatures outside this range can cause the battery liquid to leak.
Exposure to prolonged high humidity can cause corrosion of metal
components.
· Normally, the battery pack can be charged up to 500 times. However, the
battery pack can be considered dead if the period of use drops off
markedly despite the pack being charged for the aforementioned charging
time. When this happens, a new pack should be used.
· Do not dispose the battery pack due to environmental protection. At the
end of its useful life, check with your local solid waste officials for details
on recycling options or proper disposal in your area. You may also
contact to our office.
EBP-52NS (3.6V-500mAh)
About 10 hours
Battery Pack Type
Charging Time